| ID | Subject |
| 4908 | Why do I see "Broadcom BCM5751 Driver" item in the GS-SR295/GA-9ILDR driver auto run setup menu ? ...More |
| 4183 | Why does the system only show 3.5 GB of memory when I set 4GB memory on the motherboard. ...More |
| 4182 | How to configure onboard SCSI RAID on GA-9ILDR/GS-SR295 models? ...More |
| 4181 | How to configure onboard host RAID on GS-SR147S, GA-8IKHXT/8IKHDW models ? ...More |
| 4180 | How to configure onboard host RAID on GS-SR125E/222E/326E/275,GA-8EGXDRE/7A8DRH/9ITDW ? ...More |
| 4179 | How to installled DDR333 memory modules on SR-295 server? because I can't boot on DDR333 memory modules but can be work on DDR266 memory modules. ...More |
| 4178 | How to installed DDR333 memory modules on GA-9ILDR motherboard? becuase I can't boot on DDR333 memory modules but can be work on DDR266 memory modules. ...More |
| 4177 | SR-125ED support RAID 5 function. ...More |
| 4176 | Why I can't find GA-8IPXDR-E guide to Power LED connector from manual? ...More |
| 4175 | GA-8IPXDR-E server board and Intel SCRZCR/ Intel Zero Channel RAID controller fine on initial installation, after updating firmware, it get "System Check Error ID:166" on Winodws 2000 server. ...More |
| 4174 | When I install Intel Xeon 3.2GHz/533 FSB L3=2MB CPU, system will hang up during post screen. ...More |
| 4173 | When USB device is installed, it can't be recognized properly. ...More |
| 4172 | What kind of CPU can be supported on GA-8IPXDR? ...More |
| 4171 | Does a GA-8IPXDR support Intel RAIDIOS or Adaptec 2000S ZCR card? ...More |
| 4170 | Does SR147L server IDE device can be change for SATA device type? ...More |
| 4169 | Why I can't install O.S. on SR-125ED server through single hard disk without RAID function? ...More |
| 4168 | How to identify SR125E serverboard/bridge board/ backplane board version? ...More |
| 4167 | What is the difference between SR125 A4chip & B0chip? ...More |
| 4166 | Can I use the latest model 10 XP of AMD CPU under GA-7DPXDW series ? ...More |
| 4165 | Compatibility issue between the hard drives and backplane board IDE connectors of GS-SR114 ...More |
| 4164 | Apacer DDR PC2100 CL2.5 / ECC Issue ...More |
| 4163 | GBT Customer Letter To Address 8IPXDR/RedHat LAN Issue ...More |
| 4162 | What type of AMD CPU that support for Dual Processors? ...More |
| 4161 | Does the 7DPXDW motherboard only support Registered DDR RAM? I use 1 x Unbuffered DDR DIMM in any DIMM Slot (4 Slots had been tested) but the speaker beeps 1 second and stop 3 seconds; then beep-warning sound is going on. Is the problem of DIMM? Or, the system BIOS only support Registered DDR? ...More |
| 4160 | Can I use 300 watts power supply for GA-7DPXDW server board? ...More |
| 4159 | Unable to run the system when install Red Hat 7.1 and 7.2 for Adaptec 7899 ...More |
| 4158 | We have a 6ETXDR motherboard with two PIII 1200 MHz/256/133 CPUs installed, the motherboard is currently hanging when two CPUs are installed into the board. Only one CPU works functionally. (1200Mhz/256/133 cpu is being used) How to reslove this problem? ...More |
| 4157 | We tested the GA-6VTXDR-C with two Celeron 1.2/256/100/1.475 and we found out that the motherborad was switched on but only recognized a single CPU after 2 or 3 seconds. No problems with testing dual PIII.
...More |
| 4156 | We tested the GA-6VTXD with two Celeron 1.2/256/100/1.475; unfortunately the motherboard can not be switched on. There will be no problems if using only a single CPU.
We also tested it with double PIII and had no problems. Does it normally work with dual Celeron 1.2 or higher? ...More |
| 4155 | Acknowledgement of GA-7DPXDW (-C) PCB V1.0 Beta Issues ...More |
| 4149 | Promise FastTrak Series for Linux Red Hat 7.2 Installation Guide ...More |
| 4148 | Promise FastTrak Series for Linux Red Hat 7.1 Installation Guide ...More |
| 4147 | SuSE 7.1 / 7.2 Installation Guide for SR101 ...More |
| 4146 | Red Hat 6.2 and 7.0 Installation Guide ...More |
| 4145 | Why running Windows 2000 and Windows NT on SR-101, the system is not stable ‘sometime hang-up and sometime the system is crashed? ...More |
| 4144 | Can we set two hard disk to RAID 0+1 ? ...More |
| 4143 | Why we can not set two hard disk to RAID-0（Striping）or RAID-1（Mirror）? ...More |
| 4142 | When we install Cytrix Server Ver 1.8 Meta Frame software on Windows 2000 Server, the system is crashed（Blue screen）before complete .The error message isSTOP : 0x0000001E (0x00000005 ,0xf081851C ,0x00000000 ,0x00000000 )KMODE-EXCEPTION-NOT-HANDLED***Address F081851C base at F0818000Date stamp 39DCA88D –EVIAN.SYS ...More |
| 4141 | When I install Windows NT 4.0, system couldn’t detect the Hard Disk and show the installation fail. ...More |
| 4140 | When I install Windows 2000, I didn’t see the Hard Disk and install fail. ...More |
RSS